Haul Out Schedule
Posted: Sat Jan 21, 2017 9:59 am
Marinette Boat Forum
A forum for aluminum boat owners and those directly supporting them
http://marinetteboat.com/forum/
Haul Out Schedule
Page 1 of 1
Re: Haul Out Schedule
Posted: Sun Jan 22, 2017 10:55 am
Marysville Marine is were I got my non metallic cutless bearings. You just have to know the exact sizes. There is also cutless bearings in the rudder tubes, usually you have to cut the bearings in half and put one in the top side and one in the bottom.
Re: Haul Out Schedule
Posted: Sun Jan 22, 2017 11:11 am
Re: Haul Out Schedule
Posted: Sun Jan 22, 2017 1:12 pm
Carl,
Full length bearings aren't needed. The supporting points are more than adequate. Additionally, when it comes time to change them (in several years), you'd find it very tuff to remove.
NOTE - FastJeff had a process on an old site that used a reverse ground "V" chisel to remove old bearings.
Bill
Full length bearings aren't needed. The supporting points are more than adequate. Additionally, when it comes time to change them (in several years), you'd find it very tuff to remove.
NOTE - FastJeff had a process on an old site that used a reverse ground "V" chisel to remove old bearings.
Bill
Re: Haul Out Schedule
Posted: Sun Jan 22, 2017 1:37 pm
Re: Haul Out Schedule
Posted: Sun Jan 22, 2017 8:27 pm
I purchased my non-metallic bearings from this place:
https://www.deepblueyachtsupply.com/marine-bearings
Worked out great!
https://www.deepblueyachtsupply.com/marine-bearings
Worked out great!
Re: Haul Out Schedule
Posted: Tue Jan 31, 2017 6:20 am
After reading that list, boy am I glad to be a trailered, 19 foot I/O guy!
Jeff
Jeff