A little crazy?

[TinLizzy]

There was a few factory triangles cut in a few of the original webbing stringers, and we also added a few. Water does drain to the keel, although slow at times.

[Fastjeff]

Fascinating project!

Sure wish I lived nearby so I could give you a helping hand.

Jeff

[TinLizzy]

Thanks Jeff!

[TinLizzy]

Swapped trailers under boat. Borrowed a buddies trailer for it to sit on after the engines go in. Old trailer was too short and did not support the stern at all. We used a fork lift, loader and a couple tow straps to and it for the swap.

[TinLizzy]

Sitting on better trailer until I can lengthen the old one.

[TinLizzy]

Transom assemblies installed for the last time I hope!

[TinLizzy]

Engines mounted, transom assemblies installed, engines aligned, outdrives installed. Slapped some primer on the bare metal.

[Fastjeff]

Have you tried the Fastjeff jump on the cavitation plate to see if it moves test?

Jeff

[TinLizzy]

Jeff, the transom has passed the jump method, and the full throttle method. Both passed with flying colors. The welder and a couple engineers that looked it over were quite confident in the end product.

[TinLizzy]

Paint job is quite bad, I had run out of time to get a decent color match. So I just slapped some paint on it before the launching to cover up the primer. Next spring I plan on repainting the whole boat from the rub rail down to the bottom paint.