Rub rail and other parts

Post Reply
User avatar
Busia
Royal Aluminum Star
Posts: 406
Joined: Tue Jul 15, 2014 12:21 am

Rub rail and other parts

Post by Busia »

People have been asking about rub rails and inserts. This company advertises they have them. They are www.SteeleRubber.com they have a free catalog also. They also have window glazing and hatch seals.
And don't forget there is a lot of info already covered in the subforums down at the bottom of the main page. Lots to review when you have time or questions
BUSIA
located in Ketchikan, Alaska. Gods country
32 foot Marinette (no fly bridge)
twin 350 Crusader (Chev 350) engines
1:1 Borg Warner velvet drive transmissions
Closed cooling (antifreeze in the engine)
Proud to be retired IBEW and an A+P
User avatar
bcassedy
Royal Aluminum Star
Posts: 507
Joined: Sun Jul 13, 2014 10:05 am
Location: Aurora, In.

Re: Rub rail and other parts

Post by bcassedy »

Have used Steele Rubber before for rubber channel to install at sliding window edges to reduce air infiltration into boat. Works well.

Also, as mentioned by "BUSIA", there's a ton of info here on the site available through Search feature. Case in point (not hijacking subject, just FYI) our new to us 41' Maquis has a busted window In the salon. "Alumination" Bill put up a good window removal process in 'Window and tint removal thread'.

Paraphasing ... ' If you need info, search. You will find it. '

Bill
Bill & Sharon Cassedy
"Sunset Seeker"
'88 32' Sedan Bridge to be sold (updtd 1-1-22)
"Sunset Seeker Too" (SS2)
'88 41' Marquis hardtop. (as of 1/1/22)
Located in Aurora, In.
Always fresh water.
Post Reply