Carl,
I'm not at the boat but I can tell you that my '88 does NOT have that type configuration. Bottom rung/step is a full step (such as your 2 at the top). I believe the PO added that in order to make it easier to board the step platform (would extend deeper in the water). Actually, not a bad idea tho I agree with you the split at the bottom of your lowest rung is definitely a weak spot. While I haven't been overboard in a number of years (there is something to be said when addressing the "Admiral" in a polite way - no plank walkin' ) I seem to remember getting aboard was a bit of a challenge because the bottom rung/step didn't extend too far down into the water.
... I have to talk to the next whale I meet... blubber doesn't float like I was told!
Bill
Swim Ladder Question/Restoration
Swim Ladder Question/Restoration
Last edited by carl on Wed Jul 10, 2019 1:13 pm, edited 2 times in total.
Re: Swim Ladder Question
Last edited by bcassedy on Tue Jul 17, 2018 7:21 pm, edited 1 time in total.
Bill & Sharon Cassedy
"Sunset Seeker"
'88 32' Sedan Bridge to be sold (updtd 1-1-22)
"Sunset Seeker Too" (SS2)
'88 41' Marquis hardtop. (as of 1/1/22)
Located in Aurora, In.
Always fresh water.
"Sunset Seeker"
'88 32' Sedan Bridge to be sold (updtd 1-1-22)
"Sunset Seeker Too" (SS2)
'88 41' Marquis hardtop. (as of 1/1/22)
Located in Aurora, In.
Always fresh water.
Re: Swim Ladder Question
Threw my ladder away, along with the air conditioner. Never going to need them! But what you have looks like a repair or modification. I would place a longer sleeve over or inside the bottom. A sleeve could go all the way across the bottom.
BUSIA
located in Ketchikan, Alaska. Gods country
32 foot Marinette (no fly bridge)
twin 350 Crusader (Chev 350) engines
1:1 Borg Warner velvet drive transmissions
Closed cooling (antifreeze in the engine)
Proud to be retired IBEW and an A+P
located in Ketchikan, Alaska. Gods country
32 foot Marinette (no fly bridge)
twin 350 Crusader (Chev 350) engines
1:1 Borg Warner velvet drive transmissions
Closed cooling (antifreeze in the engine)
Proud to be retired IBEW and an A+P
Re: Swim Ladder Question
Hi Carl your ladder has been modified. I modified mine in a similar way but I used stainless chain and a starboard tread . The chain is small enough to fit into the down tubes of the ladder secured by the though bolts, the ends of the tread are notched just enough to accept the chain and stay aligned with down tubes. The chain is secured across bottom of the starboard tread with two small half round clips screwed in from the bottom. This mod really aides getting out of the water and looks good when you pull up the ladder not sticking up any higher than the stock ladder.
1987 32 f/b sedan with twin 318's Docked on florida's nature coast
Re: Swim Ladder Question/Restoration
Last edited by carl on Wed Jul 10, 2019 1:13 pm, edited 2 times in total.
- shade2u2
- Royal Aluminum Star
- Posts: 290
- Joined: Mon Jul 21, 2014 3:11 pm
- Location: Marietta, Ohio -mile marker 172
Re: Swim Ladder Question
My 39 has just a 2 step ladder - like your ladder started out as. My 28 has a 3 step ladder but was probably not original. The 2 step isn't much shorter than the 3 step as the steps are further apart. I have not mounted or used the 2 step on the 39 yet. From experience, the deeper into the water these steps go, the better - for this old guy anyway...
John
1986 39 Sedan w/Crusader 454 & 1.92 drive.
former - '84 28 Express Hardtop w/single 360 1.5:1 drive (SOLD - now in Uruguay)
Ohio and Muskingum Rivers (Marietta, OH)
1986 39 Sedan w/Crusader 454 & 1.92 drive.
former - '84 28 Express Hardtop w/single 360 1.5:1 drive (SOLD - now in Uruguay)
Ohio and Muskingum Rivers (Marietta, OH)
Re: Swim Ladder Question
If you are poundagely challenged, as I am, there's no way you can climb a two step ladder! I too added a step to mine, and also my new-to-me 19 foot bow rider.
Why manufacturers do that mystifies me.
Jeff
Why manufacturers do that mystifies me.
Jeff
"We live at the bottom of an ocean of air, not at the top." General Marvage Slatington
Re: Swim Ladder Question/Restoration
Last edited by carl on Wed Jul 10, 2019 1:12 pm, edited 1 time in total.
Re: Swim Ladder Question/Restoration
Carl, I want to modify my 86 Express ladder to be the same as your photo! do you think I can fabricate this from scratch? my ladder is just the swingdown - and I have a foot step mounted on the transom. I'm short and need this type of config.
If you have the old parts, I would love to borrow them for a template.
If you have the old parts, I would love to borrow them for a template.
FINALLY GOT IT!
1986 Marinette Express 32
w/twin Chrysler 318s
Located on Lake Erie
FCYC, Cleveland, OH
1986 Marinette Express 32
w/twin Chrysler 318s
Located on Lake Erie
FCYC, Cleveland, OH
Re: Swim Ladder Question/Restoration
Here's a shot of a ladder I found with the same config as I assume yours should have had from stock.
FINALLY GOT IT!
1986 Marinette Express 32
w/twin Chrysler 318s
Located on Lake Erie
FCYC, Cleveland, OH
1986 Marinette Express 32
w/twin Chrysler 318s
Located on Lake Erie
FCYC, Cleveland, OH