distributor gasket leakage
distributor gasket leakage
how easy will it be to take out the distrbutor and replace gasket while getting it back in near the same also i had a mech. try to time my motors and he said the tabs were missing in the bell housing used to set timing whats that about and how do we get timing set now thanks in advance guys
1988 32`Fisherman
Twin 360`s
Curtice OH
Twin 360`s
Curtice OH
Re: distributor gasket leakage
The distributors are removed by taking off the crows foot bracket and pulling straight up. Make sure you use a marker and scribe a reference line on the distributor and the engine block. It is a good idea to pull the cap off the distributor and note where the rotor is pointed. As the distributor can only be installed in the correct location or 180 degrees out of time.
As for a timming marks have you looked at the front of the engine similar to a engine mounted in a car.
bill
Thanks for the signature.
Last edited by bill on Mon Apr 20, 2015 7:11 pm, edited 1 time in total.
Former owner of
ALUMINATION
Grosse Ile MI
Located on LakeErie
37' F/B Sedan
1975
Twin 360 Chrysler Marine
Raw water cooled
Hydraulic steering both helms
USCG Master Lic. Retired[/color]
Third Owner bill
ALUMINATION
Grosse Ile MI
Located on LakeErie
37' F/B Sedan
1975
Twin 360 Chrysler Marine
Raw water cooled
Hydraulic steering both helms
USCG Master Lic. Retired[/color]
Third Owner bill
Re: distributor gasket leakage
As saying goes... "A picture is worth a thousand words." And with most of us having cell phones capable of taking good resolution pics, I'd recommend taking several from different angles before and during work. Being able to go back and reference a pic could save you a lot of grief later.
Bill
Bill
Bill & Sharon Cassedy
"Sunset Seeker"
'88 32' Sedan Bridge to be sold (updtd 1-1-22)
"Sunset Seeker Too" (SS2)
'88 41' Marquis hardtop. (as of 1/1/22)
Located in Aurora, In.
Always fresh water.
"Sunset Seeker"
'88 32' Sedan Bridge to be sold (updtd 1-1-22)
"Sunset Seeker Too" (SS2)
'88 41' Marquis hardtop. (as of 1/1/22)
Located in Aurora, In.
Always fresh water.
Re: distributor gasket leakage
I roll the motor over to TDC on cylinder one and verify with the timing mark. Then, if you make a mistake, setting the distributor is relatively simple. This takes a few extra minutes but will prevent chasing your tail later.
Eric
Eric
Eric Spies
1989 32 SDFB
Twin 318s
Lake Lanier, GA
1989 32 SDFB
Twin 318s
Lake Lanier, GA