Carburetor replacement

Engines, Shafts, Steering, Struts, Rudders, etc.
Robert
New poster
Posts: 6
Joined: Mon Sep 09, 2019 7:09 am

Carburetor replacement

Postby Robert » Sat May 23, 2020 8:56 am

The Rochester quadrajet (# 17086115) from my 1988 Marinette Chrysler 318 was so pitted inside that it could not be rebuilt. I was going to replace with a Edlebrock 1409 but was talked out of it due to required mods and extra cost over direct Rochester replacement.
I searched the web by my carb part number and found a replacement for only $335 and ordered.
I just received it and it is instead a Carter that is stamped as made for GMC. It has the following numbers, CJ3, 7047186, and a circled R.

Is anyone here an expert about this that can tell me if this will work fine or if I should send it back?
Thank you,
Robert.

jralbert
Site Admin
Posts: 750
Joined: Fri Jul 11, 2014 9:15 pm

Re: Carburetor replacement

Postby jralbert » Sat May 23, 2020 11:53 am

Call the vendor first and discuss the discrepancy. Often, a parts dept staffer will have valuable info. It may have been a mistake or is an acceptable substitute.
-joel-
former owner 1988 '32 FB Sedan
Chesapeake Bay
twin 318 / 240 hp
Potomac MD

Fastjeff
Site Admin
Posts: 1319
Joined: Sat Jul 12, 2014 5:06 am
Location: Rock Halll, MD
Contact:

Re: Carburetor replacement

Postby Fastjeff » Mon May 25, 2020 3:41 pm

And it MUST be a marine carb--they may have got that wrong as well.

Running an automotive carb is dangerous since it does not flood internally.

Jeff
"We live at the bottom of an ocean of air, not at the top." General Marvage Slatington