Page 2 of 4
Re: Marinette Nameplate
Posted: Thu Jan 15, 2015 11:54 am
by Docsnow
Re: Marinette Nameplate
Posted: Thu Jan 15, 2015 4:32 pm
by jralbert
Norm, I did a quick primer under General Topics. If I did it under the nameplate thread, no one would ever be able to find it
Re: Marinette Nameplate
Posted: Fri Jan 16, 2015 4:21 pm
by collins69s
I know some will say this isnt as cool as the original cast plates.. But why not just take the plate to a vinyl sign maker and have them print a couple up and stick in the proper spot on the boat? Easier to keep clean and the gunk out of and they wont break or snag you or the admiral's clothes.. Just a thought.
Re: Marinette Nameplate
Posted: Sat Jun 04, 2016 11:51 am
by RogerRose
bill wrote:
Me to
I have often wondered why somebody couldn't come up with a aluminum cast MARINETTE name plate
Sure would hold up better than plastic.
bill
put me in line
Re: Marinette Nameplate
Posted: Sat Jun 04, 2016 9:45 pm
by EWRice
I have a friend who built his own 3D printer, and loves to use it. If I could find one good emblem for my 72, I would make new ones. Mine is different from all the other emblems I have seen. I missed out on the one I need in cast aluminum on ebay a few months ago.
Re: Marinette Nameplate
Posted: Sun Jun 05, 2016 5:20 pm
by javalin390
Did you check out my post on making new plastic ones? Re-did the little tutu ones for 20 bucks (look at the other emblem post) The long M ones won't be any different.
Re: Marinette Nameplate
Posted: Wed Jun 08, 2016 12:02 pm
by EWRice
My problem is that I don't have any emblems. They were gone when I bought the boat. I have been looking all over for at least one. If I find one, I can get it 3D scanned and have one printed. But I am stuck on step 1, finding one.
Re: Marinette Nameplate
Posted: Mon Nov 28, 2016 12:32 pm
by Deanjmarinette30
can you provide me the contact for the marinette name plates... I need both port and starboard.
Dean J. 502-689=2044
Re: Marinette Nameplate
Posted: Mon Feb 27, 2017 8:39 pm
by EWRice
This is the nameplate I am looking for. This one is aluminum. If someone has an original that is good enough to scan, I will have 4 made. Two for me and two for the donor, on the house.
- $_1.jpeg (14.46 KiB) Viewed 14472 times