Marinette Boat Forum

thank you, rockit. I did cal orca and ordered 6 of these rings! thanks for the replies, I am curious on the DIY from Jeff -- I will figure that method out as well, I am sure it will come in handy with one of the other many pieces/parts I will need to get/construct.

Thank you for the replies! I did buy a sheet of cork/rubber from autozone to cut the ring. I was expecting this to be a large diameter O ring sandwiched between the cap and the brass (but, I honestly don't know). Now, I don't know what/where this o-ring will be - i thought it was this big gasket ind...

I am replacing the impellers in my 86 express/318 twins. The port strainer is showing signs of air, as well as overheating - while the starboard is a full water flow and normal temp. I am doing one adjustment at a time to see what affects the outcome: 1. change impellers - use dawn soap for lubricat...

does it have a transom ladder like the pone pictured? I am looking for the rail mounted fixed ladder. I have a swingdown.

Carl,

I don't have anything to use as the guide/template for the stainless railing. I do think I found the brackets.
I will find a way to make that happen.

OR, I'll have a tuna door put in

Praying for you and your family.

Here's my current setup three steps stock

another look

Here's a shot of a ladder I found with the same config as I assume yours should have had from stock.

Carl, I want to modify my 86 Express ladder to be the same as your photo! do you think I can fabricate this from scratch? my ladder is just the swingdown - and I have a foot step mounted on the transom. I'm short and need this type of config. If you have the old parts, I would love to borrow them fo...