Marinette Boat Forum

I just took the 1409 off my 318 after a couple years. The original Carter was leaking through the body like mentioned above. The low end adjustability of the edelbrock did not impress me at all. I do a lot of trolling and was never real happy with it. This year I put a Holley 650 single pumper on wi...

after reading an inspection post about checking the rudder for slop ( worn bushing) . I decided to check mine and discovered it has about a quarter inch slop. Is this at the point where it needs addressed and if so are there any recommendations on where to get one? Im just putting the final touches ...

Hey hyperjump! Nice pics! I also love in North East Ohio. Jefferson to be exact but I keep my M docked at brockways in ashtabula. I have a friend who is an engine builder who would be able to help you out with those heads if you decide you need it. Its nice to have a fellow member so close. I'm no e...

Excellant! Thanks! I want to do the same thing soon though it probably wont be this winter. I am working on replacing the aft deck currently and then the trailer is getting an overhaul. The information you provide is appreciated and i wish you the best of luck.

I am considering replacing the afternoon deck on my 28 express with aluminum as opposed to plywood after reading some older posts. My question is what thickness is recommended and is any extra support required with doing this? Any tips would greatly appreciated as I am about to start tearing into my...

thanks for the info! The manual for the engine states to use a .5 and 5 ohm dual resistor. what is in the boat and all i can find is a 1.2 and 5. is this a problem? I plan on switching out the coil as previously recommended but i want to make sure i have the correct resistor? The one i currently hav...

i was reading old post about orange spark and the problem with it. my 84 318 will crank but wont start i changed the coil and resistor and the ecu was replaced mid season last year. i read were fast jeff used a mallory 700 ballast resistor and an accel 8145 output coil. is this also goood for a 318 ...